Installation
3-2
E 1999 Nordson Corporation
All rights reserved
104 330H
Issued 8/99
Manual 1-8
CAUTION: The air supply line must be 9.5 mm (
3
/
8
in.)
minimum ID flexible hose. Do not connect the pump to a ridged
supply line. Operational vibrations may cause damage to the
pump.
3. Purge the air supply hose of all contaminants and connect to
the pump.
Use the optional air filter and lubricator kit to prolong air motor life. The
air lubricator must be installed between the regulator/gauge and the
pump. Install the air filter before the regulator/gauge.
Fill the lubricator with Nordson vitalizer oil, included with the kit. Refer to
your
Solvent Chamber Fluids
manual for instructions on adjusting the
lubricator on initial start-up.
0108004A
1
2
16
3
4
5
6
7
8
9
10
11
12
13
14
15
Fig. 3-1 Typical Single Gun Circulating System
1. Spray gun
2. High pressure fluid filter
3. Heater
4. Pump
5. Air lubricator
6. Air pressure gauge
7. Air pressure regulator
8. Air filter
9. Shut-off valve
10. Drop leg and drain valve
11. Solvent chamber filler cup
12. Siphon rod and strainer
13. Drain-off rod
14. Drain-off valve
15. Circulating valve
16. Filter drain valve
3. Air Connections
(contd)
Air Supply Lubrication
To Next Page
Loading...
