EasyManuals Logo

Nortel 2526T User Manual

Nortel 2526T
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Securing your network 105
eapol multihost non-eap-pwd-fmt command parameters and variables
Parameter Description
ip-addr Specifies the IP address of the non-EAP client.
mac-addr Specifies the MAC address of the non-EAP
client.
port-number Specifies the port number for which you want the
RADIUS password attribute configured.
To discontinue configuration of the RADIUS password attribute format, use
the no or default keywords at the start of the commands, in the Global
configuration mode.
Specifying the maximum number of non-EAPOL hosts allowed To
configure the maximum number of non-EAPOL hosts allowed for a specific
port or for all ports on an interface, use the following command in Interface
configuration mode:
eapol multihost [port <portlist>] non-eap-mac-max <value>
where
<portlist> is the list of ports to which you want the setting to apply.
You can enter a single port, a range of ports, several ranges, or all. If
you do not specify a port parameter, the command sets the value for
all ports on the interface.
<value> is an integer in the range 1–32 that specifies the maximum
number of non-EAPOL clients allowed on the port at any one time. The
default is 1.
ATTENTION
The configurable maximum number of non-EAPOL clients for each port is 32, but
Nortel expects that the usual maximum allowed for each port be lower. Nortel
expects that the combined maximum will be approximately 200 for each box
and 800 for a stack.
Creating the allowed non-EAPOL MAC address list To specify the MAC
addresses of non-EAPOL hosts allowed on a specific port or on all ports on
an interface, for local authentication, use the following command in Interface
configuration mode:
eapol multihost non-eap-mac [port <portlist>] <H.H.H>
where
<portlist> is the list of ports on which you want to allow the specified
non-EAPOL hosts. You can enter a single port, a range of ports, several
Nortel Ethernet Routing Switch 2500 Series
Security Configuration and Management
NN47215-505 (323165-B) 02.01 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.

Table of Contents

Other manuals for Nortel 2526T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nortel 2526T and is the answer not in the manual?

Nortel 2526T Specifications

General IconGeneral
BrandNortel
Model2526T
CategorySwitch
LanguageEnglish

Related product manuals