162 Configuring Security using the CLI
Creating a Management Target Address
To create an entry in the Management Target Address table, use the
following procedure:
Step Action
1
From the Device Manager menu bar, choose Edit > SnmpV3 >
Target Table.
The Target Table dialog box appears, with the Target Address Table
tab appears.
The following figure displays the Target Table dialog box, target
Address Table tab.
Figure 49
Target Table dialog box, Target Address Table tab
Target Address Table fields
The following table describes the Target Address Table fields.
Table 76
Target Address Table fields
Field Description
Name Specifies the name for this target table entry.
TDomain Specifies the domain of the management target. The
default is snmpUDPDomain.
TAddress Specifies the IP address and destination UDP port for
this management target, for example, 10.0.4.27:162.
Timeout Specifies the length of the time to wait in 1/100
th
of a second, for an acknowledgement from this
management target before declaring the message as
timed-out. The default is 1500 milliseconds.
RetryCount Specifies the number of times this device can
resend messages to this management target if initial
messages are not acknowledged. The default is 3.
Nortel Ethernet Routing Switch 2500 Series
Security — Configuration and Management
NN47215-505 (323165-B) 02.01 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.
To Next Page
Loading...
Need help?
General