45
6. In Pro Tools, load a project then select ‘MIDI -> Input Devices…’ from the ‘Setup’ menu and ensure ‘ReMOTE SL Port 3’
is unchecked, then click ‘OK’. This prevents Automap Universal data, intended for the Automap Server, from being
routed into Pro Tools.
The Pro Tools Automap template (template 34) must be selected on the ReMOTE SL to use it in Pro Tools Automap mode.
Once you have followed the above set up instructions, the ReMOTE SL will automatically switch to the Pro Tools Automap
template and will do so each time you subsequently start Pro Tools. Whilst using the ReMOTE SL in Pro Tools Automap
mode, you can switch to any other template on the unit (for example to control a soft-synth) and then switch back to the
Pro Tools Automap template to control Pro Tools again.
The Automap Universal server software allows tempo control from the ReMOTE SL over any ReWire host application,
including Pro Tools, and also transport control from the Automap Universal template (see sections 7.2 and 13.1). For this
tempo and transport control to work you must enable the Automap Server as a ReWire input in Pro Tools. To do this,
create a stereo aux track in your session and add an ‘Automap Universal Transport’ ReWire instrument plug-in to the first
insert slot on that track.
The ReMOTE SL can be in one of three modes when controlling Pro Tools: Track mode, Flip mode or Insert mode. The left-
hand ReMOTE SL display shows information fed back from Pro Tools, which will be different depending on which mode the
ReMOTE SL is in, as detailed in the following sections. The right-hand display shows the names and values/states of the
currently selected row of controls on the right-hand side of the ReMOTE SL.
To Next Page
Loading...
