Novation ReMOTE SL User Manual

8
4 GeTTING STARTeD WITH THe ReMOTe SL
4.1 POWeRING THe ReMOTe SL
The ReMOTE SL can be powered in one of three ways:
USB: Connect the ReMOTE SL to a computer using the supplied USB cable and set the power select switch to ‘USB’.
PSU: Connect a mains PSU to the ReMOTE SL and set the power select switch to ‘Battery/Ext DC’. The required PSU
output specs are 9V, 600-1000mA d.c., centre pin positive.
Battery: Insert four 1.5V IEC R14 (C size) batteries into the battery compartment of the ReMOTE SL and set the power
select switch to ‘Battery/Ext DC’.
4.2 INSTALLATION - PC
The latest ReMOTE SL installer is compatible with Windows XP SP2, XP X64 and Vista (32 and 64 bit editions).
Connect the ReMOTE SL to your computer via USB and ensure it is switched on. If the Windows Found New Hardware
Wizard opens, click ‘Cancel’ to close it. If you already have an older version of Automap Universal installed, make sure
the Automap Server is NOT running.
Double-click on ‘ReMOTESLSetup.exe’ to run the installer.
Whilst the driver is installing, the following message may appear:
Win XP Win Vista
Click ‘Continue Anyway’ (Win XP) or ‘Install’ (Win Vista) to continue installation.
4. Once the driver is installed, you will be prompted to select whether you have a keyboard version of the ReMOTE SL
or a ReMOTE SL ZeRO.
The installer will then guide you through updating your ReMOTE SL with on-screen instructions. Please read and follow
these instructions carefully to ensure the unit gets updated correctly.
1.
2.
3.

Novation ReMOTE SL Specifications

General

Velocity Sensitive	Yes
Aftertouch	Yes
Faders	8
Knobs	8
Pads	No
Type	MIDI Controller
Automap Software	Yes
Number of Keys	25, 49, 61
Display	LCD
Connectivity	USB, MIDI In/Out
Power Supply	USB
Pedal Inputs	2 (Sustain, Expression)