65
14 EDIT MODE
In Edit mode you can access the settings for each individual assignable control on the ReMOTE SL (all encoders, pots,
sliders, buttons, the joystick, the X-Y touchpad, transport buttons and pedals). These settings define what MIDI message
is sent when the control is operated. To access the settings for a particular control press and hold the EDIT mode button
and then operate the control you want to edit.
The joystick and X-Y touchpad are the only controls on the ReMOTE SL that can have more than one MIDI message
assigned to them. The joystick can be assigned separate messages for the horizontal (pitch) and vertical (mod) axes. Press
and hold EDIT mode button and move the joystick left to right to access the settings for the horizontal (pitch) axis or move
it up and down to access the settings for the vertical (mod) axis.
The X-Y touchpad can have up to four MIDI assignments; two on the X axis (horizontal) and two on the Y axis (vertical).
Press and hold the EDIT mode button and then touch the area of the touchpad that corresponds to the axis whose
settings you want to edit:
In Edit mode the right-hand display shows which control is currently selected for editing along with the user-defined name
for that control:
The left-hand display shows the available settings for the currently selected control. Once you have selected a control to
edit, use the SCROLL buttons to scroll through pages of settings for the control (there will be between 1 and 3 pages of
settings, depending on the type of control).
If a control is not already assigned to send a MIDI message then when you select it in Edit mode the left-hand display will
look like this:
The Control setting is the first one you will set as it defines the type of MIDI message the control sends. If you are not
familiar with any of the different types of MIDI messages listed in the table below (with the exception of ‘Template’ they are
all defined in the MIDI Specification) then we suggest doing some background reading on MIDI at this point so that you can
better understand the options available in Edit mode.
SLIDER 1 [Env Attk]
To Next Page
Loading...
