Novation ReMOTE SL - Template; System Real Time (Realtime); Pitch Bend (Pitchbnd)

75
a note off message after the selected note length has passed. If you are recording notes into a sequencer then you will
need to make sure that you are sending MIDI clock from the sequencer to the ReMOTE SL and that the ReMOTE SL is set
to sync to incoming MIDI clock (see section 11 for information on setting the MIDI clock source). The range of the note
length setting ranges from 32nd triplet to 12 bars. When selecting a note length, ‘T’ indicates a triplet note length and ‘D’
indicates a dotted note length.
14.10 TEMPLATE
This option is different to the others in that it is not a type of MIDI message. Instead this option allows you to set any
button, drum pad or the sustain pedal to switch to another template on the ReMOTE SL. No MIDI message is sent when
you operate a Template control. There is only one setting available:
Template:
This sets the template number that the unit will switch to when the control is operated.
14.11 SYSTEM REAL TIME (REALTIME)
The Ports and Name settings are the same as for Control Change (CC) so see that section for information on these
settings.
LowVal (Low Value) and HighVal (High Value):
These define the Low and High control value and should be set in
conjunction with the BtnType parameter (see below). The available options for this setting are standard MIDI system real
time messages: start (RT-Start), continue (RT-Contu), stop (RT-Stop), active sensing (RT-Actvs) and system reset (RT-Reset).
BtnType: This is exactly as described for Control Change (CC) however the ‘STEP’ option and also the ‘VELOCITY’ option
for drum pads are not available. If this is set to ‘NORMAL’ then the button will send the Low Value message when pressed
and nothing when released. If this is set to ‘TOGGLE’ then alternate presses of the button will send the Low Value and High
Value messages. This means that if Low Value is set to ‘RT-Start’ and High Value to ‘RT-Stop’ you can use a single button to
start and stop the transport on the receiving device.
14.12 PITCH BEND (PITCHBND)
This option only applies to the X-Y touchpad and horizontal (pitch) axis of the joystick. No other controls on the ReMOTE SL
can be assigned to send pitch bend messages. There are no options for limiting the control value as this can be done on the
instrument you are controlling by altering the pitch bend up/down range (if the option is available). The Ports, MidiChan and
Name settings are the same as for Control Change (CC) so see that section for information on these settings.