MIDI Volume – sets the MIDI Volume from 0 to 127
To view the Panning parameters, press the downward Effect Select button once more so that the Panning
LED is active. Once in the Panning (Effects) Menu, use the page up/down buttons next to the LCD screen
to cycle through the following pages, using the data encoder to change the settings for each page:
PAN Position – sets the permanent pan position from fully left (-64) to fully right (+63)
PAN Mod Rate – sets the rate at which the signal oscillates between left and right extremes
PAN Init Posn – sets the start point of the signal to Left, Middle or Right. Setting to OFF makes the signal
begin in a random position, unless no panning modulation is occurring
Delay, Chorus and Panning effects can all be synchronised to MIDI clock from the sequencer (received
over USB). This is set up in the Sync Menu (see the Sync Menu section for details).
To Next Page
Loading...
