The 2-D controls Menu (Xpression pad and stick)
The 2-D controls Menu allows the function of the Xpression pad and joystick to be edited. All preset synth
patches have the Xpression pad set up on the filter frequency (x-axis) and resonance (y-axis) but this can be
changed within this Menu. Similarly, the joystick horizontal function and vertical function can be set.
To access the 2-D controls Menu, press the Menus/Audio button (so that the lower LED lights) followed
by the button above ‘pitch/mod/pad’. Once in the 2-D Controls Menu, use the page up/down buttons next
to the LCD screen to cycle through the following pages, using the data encoder to change the settings for
each page:
BW Osc1 Bend – sets the amount of pitch bend across the joystick (horizontal motion) for oscillator 1
between -12 and +12 semitones
BW Osc2 Bend – sets the amount of pitch bend across the joystick (horizontal motion) for oscillator 2
between -12 and +12 semitones
BW Osc3 Bend – sets the amount of pitch bend across the joystick (horizontal motion) for oscillator 3
between -12 and +12 semitones
MW Pitch Direct – increases/decreases the amount of Oscillator pitch variation in semitones when
modulation (joystick vertical motion) is increased
MW Pitch Mod – sets the amount that modulation (joystick vertical motion) results in LFO1 modulating
Oscillator pitch
MW Filter Freq – sets the amount that modulation (joystick vertical motion) affects the filter frequency.
A negative value decreases the filter frequency as modulation is increased and a positive value increases it
MW Filter Freq Mod – sets the amount that modulation (joystick vertical motion) results in LFO2 modulating
the filter fr
equency
MW Output Level – allows modulation (joystick vertical motion) to control the overall output level. A positive
value makes the volume increase with modulation and a negative value makes the volume decrease
MW Delay Level – allows modulation to contr
ol the send level to the Delay ef
fect. A positive value will
increase the send level and a negative one will decrease it
MW Reverb Level – allows modulation to contr
ol the send level to the Reverb effect. A positive value will
increase the send level and a negative one will decrease it
MW Chor
us Level –
allows modulation to contr
ol the send level to the Chorus effect. A positive value will
increase the send level and a negative one will decrease it
MW Distort Level – allows modulation to control the send level to the Distortion effect. A positive value will
increase the send level and a negative one will decrease it
To Next Page
Loading...
