3. Operation
— 3-1 —
3. Operation
3.1. Operation Mode and Input/Output
There are two ways to input signals to the Driver Unit CN2: control Input/Output connector and
remote input by the CN6: interface connector. There are two operation modes to receive those
inputs exclusively.
◊ Fieldbus mode: The prompt of the Handy Terminal is “#”.
◊ Maintenance mode: The prompt of the Handy Terminal is “
:”.
The operation mode and format of Inpt/Output are shown in the Table 3-1 “Operation mode and
composition of Input/Output” (The function assignment is the shipping set).
◊ The operative Inputs/Outputs of each operation mode are shown in the bold line boxes below.
Table 3-1: Operation mode and composition of Inputs/Outputs
m: A register number derived from the top station number
Input/Output Fieldbus mode Maintenance mode
Port code
Signal
code
Remote
Input/Output
CN2
Pin No.
Remote
Input/Output
CN2
Pin No.
PI0 EMST RYm0 3 RYm0 3
PI1 ACLR RYm1 4 RYm1 4
PI2 OTP RYm2 5 RYm2 5
PI3 OTM RYm3 6 RYm3 6
PI4 SVON
RYm4
‒
RYm4
‒
PI5 RUN
RYm5
‒
RYm5
‒
PI6 STP
RYm6
‒
RYm6
‒
PI7 PRG0
RYm7
‒
RYm7
‒
PI8 PRG1
RYm8
‒
RYm8
‒
PI9 PRG2
RYm9
‒
RYm9
‒
PI10 PRG3
RYmA RYmA
‒
PI11 PRG4
RYmB
‒
RYmB
‒
PI12 PRG5
RYmC RYmC
‒
PI13 PRG6
RYmD
‒
RYmD
‒
PI14 PRG7
RYmE RYmE
‒
PI15 JOG
RYmF
‒
RYmF
‒
Input
PI16 DIR
RY(m＋1)0
‒
RY(m＋1)0
‒
PO0 DRDY RXm0 8 RXm0 8
PO1 WRN
RXm1
‒
RXm1
‒
PO2 OTPA
RXm2
‒
RXm2
‒
PO3 OTMA
RXm3
‒
RXm3
‒
PO4 SVST
RXm4
‒
RXm4
‒
PO5 BUSY
RXm5
‒
RXm5
‒
PO6 IPOS
RXm6
‒
RXm6
‒
Outpu
PO7 NEARA
RXm7
‒
RXm7
‒
In case of the fieldbus mode, take the input signals from the CN6 connector. For the maintenance
mode, take them through the CN2 connector. However, there are following two exceptions.
◊ The port assigned to the Input EMST (Emergency stop) regards the Input of both CN2 and CN6
connectors as the “Emergency stop” signal. This means that the system gets in the emergency
stop state by either one of the inputs.
To Next Page
Loading...
Need help?
General
