Numatic TTV 678 - Emergency Stop Button and Horn; Machine in Use Procedures

38
Note: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles..
Emergency Stop Button and Horn
Machine In Use
The TTV 678 is equipped with an electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop isolator button
The machine will be disabled.
To reset, turn the isolator button clockwise (see Fig.34).
After resetting the emergency stop button, to restart the
machine, turn the ignition key to the off then the on
position again.
The horn is located on the right-hand side of the operator
control panel (see Fig.35).
To operate, select forward or reverse, press the accelerator pedal.
Vacuum pick-up, water-ow and chemical-dose will turn on
automatically and the machine will move forward.
The clean-water / chemical mix is dispersed evenly via ‘THRU- FEED’
scrubbing brushes.
The waste-water is then retrieved by the suction oor-tool (see Fig.36).
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on inclines that exceed 11%.
On heavily soiled oors use a ‘double scrub’ technique.
First pre-scrub the oor with the oor-tool in the raised position,
allow the chemical time to work then scrub the area a second time
with the oor-tool lowered.
If streaking occurs wipe oor-tool blades clean.
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED
! !
34
35
36
Machine Operation