nVent RAYCHEM Elexant 4010i/4020i User Manual
RAYCHEM-AR-H60624-40X0iOpsManual-EN-1905 nVent.com
|
76
Figure 115 - Voltage Measurement Setting
Value Description Default
Value
Range
Voltage Measure-
ment
using 3-phase variants of the Elexant
4010i/4020i controllers. It has two options:
detailed information regarding 3PH heater
-
rations.
L-N
L-N
L-L
Table 27 - Voltage Measurement
NOTE:
Check the Voltage Turns Ratio and adjust its setting within the correct range.
5.8.3.2 Voltage Turns Ratio
Purpose:
The Voltage Turns Ratio adjusts voltage readings for applications where a control module is switching
voltage level than the trace voltage.
controller.
Figure 116 - Voltage Turns Ratio Setting
Range:
Default: 1.00
Procedure:
•
module input voltage
•
IMPORTANT:
the heating circuit power using the adjusted current and voltage readings. Voltage alarms also use the
adjusted voltage reading.
To Next Page
Loading...
Need help?
General
