nvent RAYCHEM T2000 - Appendix D Card Rack Dimensions

81 pages

To Next Page

To Previous Page

74 | nVent.com

APPENDIX D CARD RACK DIMENSIONS

Cutout Dimensions: 5.33” X 18.23”

Mounting: Use (4) clips provided with the Card Rack.

Main Page

Table of Contents2
Certification4
Conducted and Radiated Emissions-FCC/DOC Statement of Compliance4
General Instructions4
Introduction4
Limited Warranty4
Important Warnings and Notes5
Technical Support5
Section 1 Overview6
- Introduction6
- External Programming Devices8
- Control Module Overview9
- AC 2000+ Card Overview11
- Component Ordering Guide12
Section 2 Installation and Wiring15
- Introduction15
- Initial Inspection15
- Operating Environment15
- Installation Location15
- Mounting Procedures15
- Wiring17
- Initial Power up18
Section 3 Control Module Programming and Configuration19
- Introduction and Initial Power-Up19
- Front Panel Features19
- Displayed Alarm Indicators21
- Point Setup Parameters24
- Alarm Settings32
Section 4 Control Module Monitored Parameter Details40
- Introduction40
- Analog Readings40
- Maintenance Data41
Section 5 Control Module Control Modes43
- Introduction43
- Switch Control Modes43
- Load Shedding Control Mode45
- Ambient Temperature Control (ATC) Mode46
Section 6 Control Module Troubleshooting47
- Operator Checks47
- Common Problem Areas47
- Common Alarms-What to Look for50
Section 7 AC 2000+ Programming and Configuration53
- Introduction53
- Initial Configuration53
- Input/Output Ports54
- Operational Configuration56
- Remote Data Access58
- AC 2000+ Alarms - What to Look for59
Section 8 Maintenance60
- Operator Maintenance60
- Replaceable Parts60
Appendix A Specifications61
Appendix B RAYCHEM T2000 HTC Component Wiring Diagrams64
- Control Module / CT 2000 Contactor Wiring Diagram64
- Control Module / CT 2000-HAZ Single Pole SSR Wiring Diagram65
- Control Module / CT 2000-HAZ Two Pole SSR Wiring Diagram66
- AC 2000 Alarm / Communications Interface Card Wiring Diagram67
- B.5 AC 2000+ Alarm Communications Interface Card Wiring Diagram68
- AC 2000+ Local Port RS-232 Connections69
- External Alarm and Warning Relay Connections69
- CR 2000 Card Rack Terminal Assignments70
- CR 2000 Rev. a Card Rack Terminal Assignments71
- CR 2000+ Card Rack Terminal Assignments72
Appendix C Label Details73
Appendix D Card Rack Dimensions74
Appendix E Load Shedding Operations75
- Ac 2000+ Load Shedding Sequence75
- Control Module Load Shedding Sequence76
Appendix F 100 W PLATINUM RTD Table77
Appendix G Factory Default / Configuration Sheets78
- CM 2000 Control Module V2.35 Configuration Sheet78
- CM 2000+ Control Module V3.1X Configuration Sheet79

nvent RAYCHEM T2000 - Appendix D Card Rack Dimensions

Table of Contents

Related product manuals