nvent RAYCHEM T2000 User Manual

2 | nVent.com
CONTENTS
Introduction 4
Certication 4
General Instructions 4
Limited Warranty 4
Conducted and Radiated Emissions—FCC/DOC Statement of Compliance 4
Technical Support 4
Important Warnings and Notes 5
Section 1 Overview 6
1.1 Introduction 6
1.2 nVent RAYCHEM T2000 Components 6
1.3 External Programming Devices 8
1.4 Control Module Overview 9
1.5 AC 2000+ Card Overview 11
1.6 Component Ordering Guide 12
Section 2 Installation and Wiring 15
2.1 Introduction 15
2.2 Initial Inspection 15
2.3 Operating Environment 15
2.4 Installation Location 15
2.5 Mounting Procedures 15
2.6 Wiring 17
2.7 Initial Power Up 18
Section 3 Control Module Programming and Conguration 19
3.1 Introduction and Initial Power-Up 19
3.2 Front Panel Features 19
3.3 Displayed Alarm Indicators 21
3.4 Point Setup Parameters 24
3.5 Alarm Settings 31
Section 4 Control Module Monitored Parameter Details 39
4.1 Introduction 39
4.2 Analog Readings 39
4.3 Maintenance Data 40
Section 5 Control Module Control Modes 42
5.1 Introduction 42
5.2 Switch Control Modes 42
5.3 Load Shedding Control Mode 44
5.4 Ambient Temperature Control (ATC) Mode 45
Section 6 Control Module Troubleshooting 46
6.1 Operator Checks 46
6.2 Common Problem Areas 46
6.3 Common Alarms—What to Look For 49
Section 7 AC 2000+ Programming and Conguration 52
7.1 Introduction 52
7.2InitialConguration 52
7.3 Input/Output Ports 53
7.4OperationalConguration 55
7.5 Remote Data Access 57
7.6 AC 2000+ Alarms – What to Look For 58

nvent RAYCHEM T2000 Specifications

General

Brand	nvent
Model	RAYCHEM T2000
Category	Controller
Language	English