NXP Semiconductors Layerscape LS1028A BSP - Page 105

Parameters Description
qbvset command
--device <ifname> Interface, such as eth0/sw0p0
--entryfile <filename>
A file script to input gatelist format:
#'NUMBER' 'GATE_VLAUE' 'TIME_LONG'
#
#NUMBER:
# 't' or 'T' head. Plus entry number. Duplicate entry number will
got error.
#
#GATE_VALUE:
# format: xxxxxxxxb .
# The MS bit corresponds to traffic class 7. The LS bit to traffic
class 0.
# A bit value of 0 indicates closed, A bit value of 1 indicates
open.
#
#TIME_LONG:
# nanoseconds. Do not input 0 time long.
t0 11101111b 10000
t1 11011111b 10000
NOTE: entryfile parameter is must set. If not set, a vi text editor
prompt is required to input the gate list.
--basetime <value>
AdminBaseTime
--cycletime <value> AdminCycleTime
--cycleextend <value> AdminCycleTimeExtension
--enable | --disable
enable: enable the qbv for this port
disable: disable the qbv for this port
Default to set enable if no enable or disable input
--maxsdu <value> queueMaxSDU
--initgate <value> AdminGateStates
--configchange ConfigChange. Default set to 1.
--configchangetime <value> ConfigChangeTime
cbstreamidget command
--device <ifname> Interface, such as eth0/sw0p0
--index <value> Index entry number in this controller. Must have.
Table continues on the next page...
Device Drivers
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
NXP Semiconductors
105