NXP Semiconductors Layerscape LS1028A BSP - Page 106

Table continued from the previous page...
Parameters Description
qcisfiset command
--device <ifname> interface, such as eth0/sw0p0
--enable | --disable
enable: enable the entry for this index
disable: disable the entry for this index
default to set enable if no enable or disable input
--maxsdu <value> Maximum SDU size.
--flowmeterid <value> Flow meter instance identifier index number.
--index <value> StreamFilterInstance. Index entry number in this controller.
--streamhandle <value>
StreamHandleSpec
This value corresponds to “ tsnStreamIdHandle ” of
“ cbstreamidset ” command.
--priority <value> PrioritySpec
--gateid <value> StreamGateInstanceID
--oversizeenable StreamBlockedDueToOversizeFrameEnable
--oversize StreamBlockedDueToOversizeFrame
qcisfiget command
--device <ifname> Interface, such as eth0/sw0p0
--index <value> Index entry number in this controller. Must have.
qcisgiset command
--device <ifname> Interface, such as eth0/sw0p0
--index <value> Index entry number in this controller. Must have.
--enable | --disable
enable: enable the entry for this index. PSFPGateEnabled
disable: disable the entry for this index
Default to set enable if no enable or disable input
--configchange configchange
--enblkinvrx PSFPGateClosedDueToInvalidRxEnable
--blkinvrx PSFPGateClosedDueToInvalidRx
--initgate PSFPAdminGateStates
--initipv AdminIPV
--cycletime Default not set. Get by gatelistfile.
--cycletimeext PSFPAdminCycleTimeExtension
--basetime PSFPAdminBaseTime
Table continues on the next page...
Linux kernel
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
106
NXP Semiconductors