NXP Semiconductors Layerscape LS1028A BSP - Page 107

Table continued from the previous page...
Parameters Description
--gatelistfile
PSFPAdminControlList. A file input the gate list:
#'NUMBER' 'GATE_VLAUE' 'IPV' 'TIME_LONG'
'OCTET_MAX'
#
#NUMBER:
# 't' or 'T' head. Plus entry number. Duplicate entry number will
got error.
#
#GATE_VALUE:
# format: xb
# The MS bit corresponds to traffic class 7. The LS bit to traffic
class 0.
# A bit value of 0 indicates closed, A bit value of 1 indicates
open.
#
#IPV:
# 0~7
#
#TIME_LONG:
# nanoseconds. Do not input 0 time long.
#
#OCTET_MAX:
# The maximum number of octets that are permitted to pass the
gate.
# If zero, there is no maximum.
t0 1b -1 50000 10
qcisgiget command
--device <ifname> interface like eth0/sw0p0
--index <value> index entry number in this controller. Must have.
qcifmiset command
--device <ifname> Interface, such as eth0/sw0p0
--index <value> Index entry number in this controller. Must have.
--disable Not set disable then to be set enable.
--cir <value> cir. kbit/s.
--cbs <value> cbs. octets.
Table continues on the next page...
Device Drivers
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
NXP Semiconductors
107