NXP Semiconductors Layerscape LS1028A BSP - Page 108

Table continued from the previous page...
Parameters Description
--eir <value> eir.kbit/s.
--ebs <value> ebs.octets.
--cf cf. couple flag.
--cm cm. color mode.
--dropyellow drop yellow.
--markred_enable mark red enable.
--markred mark red.
qcifmiget command
--device <ifname> Interface, such as eth0/sw0p0
--index <value> Index entry number in this controller. Must have.
qbuset command
--device <ifname> Interface, such as eth0/sw0p0
--preemptable <value>
8 bit hex value. Example: 0xfe
The MS bit corresponds to traffic class 7. The LS bit to traffic
class 0.
A bit value of 0 indicates express. A bit value of 1 indicates
preemptable.
cbsset command
--device <ifname> Interface, such as eth0/sw0p0
--tc <value> Traffic class number.
--percentage <value> Set percentage of tc limitation.
--all <tc-percent:tc-percent...> Not supported.
cbsget command
--device <ifname> Interface, such as eth0/sw0p0
--tc <value> Traffic class number.
regtool command
Usage: regtool { pf number } { offset } [ data ]
pf number: pf number for the pci resource to act on
offset : offset into pci memory region to act upon
data : data to be written
ctset command
--device <ifname> Interface, such as eth0/sw0p0
Table continues on the next page...
Linux kernel
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
108
NXP Semiconductors