Nytech DC-7200 - Page 31

Nytech DC-7200 Capturing Pictures
English - 25
Adjusts the white balance for fluorescent light. Try also
the
setting.
Adjusts the white balance for fluorescent light. Try also
the
setting.
Manual white balance (to enable, press the shutter button
[3], see below for a detailed description).
Manual White Balance
Select Custom WB with the icon
from the White Balance menu (see
above) and press the shutter [3] halfway down. In the centre of the display
[12] a frame will appear.
The following options are available:
Button Description
SH1
(Shutter)
Customise
Focus the displayed frame onto a white surface near the
subject and then press the (Shutter) button [3] halfway
down again.
Menu Exit
Exits the manual white balance without changes.
When manually adjusting the White Balance, the white surface within the
frame will be used as reference for the colour temperature. If the metering
was successful and the colour temperature has been determined correctly,
confirm the message Custom WB? on the display by pressing the Set
button [8]. To repeat the calibration, press d on the four-way button and
confirm the Back option (icon
) by pressing the Set button [8]. Then
you can perform a new metering.