O&O CSB-XT - 6 Programming; Basic Functions

- 19 -
6. PROGRAMMING
6.1 BASIC FUNCTIONS
To access programming, press button F for 2 seconds.
Programming is divided into 3 levels.
To go to the next level keep key F pressed and press the + key (Sequence 1-2-3-1.......).
After selecting the level wanted, press push button F to display the functions available in consecutive order. Each time F is pressed
it corresponds to a function ( -  -  - .....)
With the function set, use the
+
or
-
key to change the values of the parameters (
+
: ---... /
-
: ...---).
The changes made to the parameters are active immediately but will be saved when exiting the menu, selecting the  function with
key F.
PLEASE NOTE: If there is a black out when programming, all changes will be lost.
F
-+
F
F
2
nd
level
 =arm closed
F
F
F
F
F
F
F
F
F
F
F
FF+
+
+
+
-
-
-
+
+
+
+
+
+
+
+
x 2”
x 2”
x 5 x 3x 4
1st level
programming
Selects each
single 1st level
function
(see table par.6.2)
Selects each
single 2nd level
function
(see table par.6.3)
Selects each
single 3rd level
function
(see table par.6.4)
Changes the va-
lues of each single
1st level function
(see table par.6.2)
Changes the va-
lues of each single
2nd level function
(see table par.6.3)
Changes the va-
lues of each single
3rd level function
(see table par.6.4)
“” function
Exit and save
programming
2nd level
programming
3rd level
programming
Selecting Output2 on closed arm:
A
B
C D
E
Example: