RemarksAction
Disconnect the power plug.
Note:
This step is to ensure
your own personal safety
and to help protect your
device from potential
damage.
4
Clean the scanner feeding bed.
This is the flat surface in front
of the insertion slot. Wipe thor-
oughly so dirt and dust are not
dragged into the scan area with
the original.
5
Open the scanner lid. - Press the
lid release buttons.
The internal scan area should be
wiped clean for any dust accumu-
lated during packaging and
shipping. The scan area is under
the scanner lid so you have to
open it.
The scanner lid release buttons
are at the back of the lid.
1. Stand at the front of the scan-
ner.
2. Simultaneously slide the re-
lease buttons towards the scan-
ner's center with your fingers
until you feel them unlock.
3. Use your other fingers to grip
the edge of the lid.
6
Chapter 3 - Installation16
Installation
To Next Page
Loading...
Need help?
General
