124 User manual
Define the time-outs
About the time-out settings
Introduction
You can use time-out settings to define the behaviour of the Océ TDS400-CS
if the Océ TDS400-CS remains unused for a time.
Time-out settings of the Océ TCS4 scanner
You can define the following time-out settings for the Océ TCS4 scanner.
■ The set time-out of an opened set in a copy job.
When the scanner remains unused for a time after a set was opened, the set
closes automatically.
■ The panel time-out of the scanner operator panel.
When the scanner operator panel remains unused for a time, the scanner
operator panel returns to the home screen automatically. The Océ TCS4
scanner is ready for the next user.
■ The sleep mode time-out of the scanner.
When the Océ TCS4 scanner remains unused for a time, the Océ TCS4
scanner enters the sleep mode automatically and saves energy. When the
Océ TCS4 scanner enters the sleep mode, the job settings are set to default.
Note: The time that the Océ TCS4 scanner enters the sleep mode depends on
the values of the above settings and the status of the Océ TCS4 scanner.
Time-out settings of the Océ TDS400 printer
You can define the following time out settings for the Océ TDS400 printer.
■ The sleep mode time-out of the printer.
When the Océ TDS400 printer remains unused for a time, the Océ TDS400
printer enters the sleep mode automatically and saves energy.
Note: There is no sleep mode time-out for the Océ Power Logic
®
controller.
To Next Page