Oce TDS400-CS - Make a Copy and Add a Strip

Copy jobs 201
Make a copy and add a strip
Introduction
You can use a strip to file a drawing. Use 'Add strip' to copy an original without
a strip and add a strip to the copy. Use 'Remove strip' to copy an original with
a strip and remove the strip from the copy. You can adjust a strip at the leading
or trailing side of a copy.
Before you begin
If you must enter the same value for a setting very often, you can set this value
as the default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer
queue of the Océ Queue Manager, a scan-to-file job appears in the selected
destination of the Océ Scan Manager.