Oce TDS400-CS - Connect to the Controller

Get to know the Océ Power Logic® controller applications 67
Connect to the controller
Introduction
After you start one of the Océ Remote Logic
®
applications, you must connect
to the Océ Power Logic
®
controller of the Océ TDS400-CS. You must connect
to the system for every separate application.
You can do the following when you connect to the controller.
■ Select a system from the drop-down list.
■ Add a system to the drop-down list.
■ Remove a system from the drop-down list.
When the Océ TDS400-CS is not available in the 'Connect to' dialogue box,
you must add the Océ TDS400-CS to the list of available systems.
How to connect to a system
1.
Open the application you want to run.
2. From the 'File' menu, select 'Connect to'.
3. Select the system from the drop-down list.
4. Click 'OK'.
Note: From the 'File' menu, select 'Options' to define the default system. This
is recommended if you frequently connect to the same system.
How to add a system
1.
From the 'File' menu, select 'Connect to'.
2. Click 'Edit'.
The 'Edit systems' dialogue box appears.
3. Enter the IP address or the name of the system in the 'Systems' box.
4. Click 'Add'.
The system is added to the list.
5. Click 'OK' 2 times to return to the application.