Oce TDS400-CS - Page 7

Contents 7
Chapter 7
Prepare the Océ TDS400-CS for use
Turn the Océ TDS400-CS on and off 108
Turn the Océ TCS4 scanner on and off 108
Turn on and shut down the Océ Power Logic® controller 110
Turn the Océ TDS400 printer on and off 111
Print the menu card of the Océ TDS400 printer 112
Print the configuration report of the Océ TDS400 printer 113
Print the demo print of the Océ TDS400 printer 114
Define the display languages 115
Define the display languages of the scanner and the controller 115
Define the display language of the printer 116
Define the network settings 117
Define the network settings with the Océ Settings Editor 117
Define the network settings at the printer operator panel 118
About the network settings 118
Access the system settings in the system menu 119
Define the DHCP server 120
Define the IP address 121
Define the subnet mask 122
Define the default gateway 123
Define the time-outs 124
About the time-out settings 124
Behaviour of the unused Océ TCS4 scanner and time-out settings 125
Define the sleep mode time-out of the Océ TCS4 scanner 126
Define the panel time-out of the scanner operator panel 127
Define the set time-out of a copy job 128
Define the manual feed time-out at the printer operator panel 129
Chapter 8
Set up your workflow with the Océ Power Logic® controller applications
Introduction 132
Set up your workflow with the Océ Settings Editor 133
Define the job templates 133
Define the automatic original feed setting 135
Define the original release mode 136
Create the stamps and their default settings 137
Define the media series 138