4: Sample Experiments
Note
OOIBase32 has options to either store data for each acquisition, or to collect data only
after a specified delay. Several factors affect the minimum time acquisition frequency,
including integration time, number of spectrometer channels, samples averaged, and
computer speed. If you instruct OOIBase32 to store data every 100 milliseconds, the
delay between data acquisitions will be 100 milliseconds or more, depending on your
experimental configuration. OOIBase32 spends a large amount of time calculating,
rendering, and displaying the spectra in a spectral window. You can suspend the graph
display, which greatly improves the performance of OOIBase32.
7. Enter an Initial Delay to set the delay preceding the time acquisition process. Keep in mind that
the delay countdown does not begin until you start the time acquisition process. Be sure to select
Hours, Minutes, Seconds, or Milliseconds immediately to the right of the initial delay entry.
8. Enter a value to set the Frequency of the data collected in a time acquisition process. OOIBase32
stamps data from a time acquisition with a time accurate to one millisecond. Be sure to select
Hours, Minutes, Seconds, or Milliseconds immediately to the right of the frequency entry. You
can enable the Save Every Acquisition box to store the acquisitions that occur at this frequency.
See Step 6 for more information.
9. Enter a value to set the Duration for the entire time acquisition process. Be sure to select Hours,
Minutes, Seconds, or Milliseconds to the right of the duration entry. Click the OK button to close
the Time Acquisition Configuration dialog box. Then, enable Continue Until Manually
Stopped, which instructs OOIBase32 to store data until you manually stop the acquisition
process (optional).
197-00000-512-02-0305 31
To Next Page
Loading...
