44
Fig. 51- Lower Portion of Module
Fig. 52 -Upper Portion of Module
Installing the Module into a Boot
• DO NOT use tools or lubricants, doing so could damage
the module or boot.
• Hold the Module over the Boot (both facing you).
• Slide the lower/front portion of the Module down into the
cavity of the Boot (Fig. 51).
• Place the fingers of your left hand inside the upper/back
portion of the Boot.
• Carefully stretch and pull the top (upper/front portion) of
the Boot upward and toward you while simultaneously
pressing the top (upper/right portion) of the Module into
the Boot (Fig. 52).
• Press firmly until the upper/right arm of the Module slides
over the retaining lip inside the Boot.
• Repeat for the left side.
• Ensure that the edges of the Boot (front and back) are not
curled and the pressure sensor opening is clear.
To Next Page
Loading...
