OCULUS Myopia Master Advanced - Save the IOP Data

17 Calculated correction of tonometrically measured IOP
66 / 92 Instruction Manual Myopia Master® (G/68100/EN Rev04 0820)
Note
By default, the IOP correction is calculated by the correction formula,
which was selected in the settings.
If another formula should be used (for example myopic post-LASIK), you
can select it on the screen of the IOP correction.
 Enter the IOP value by pressing and turning the control wheel.
 Confirm the IOP value with the button [Save].
The corrected IOP value appears:
17.4.1 Save the IOP data
 Store the patient data of the examination (fig. 12-5, page 32).
 Printout the data.
On the printout you can find the following IOP values:
 IOP-Table
 IOP Change
 IOP Measured
 IOP corrected
1 Corrected IOP value
Fig. 17-5: Corrected IOP
1