ODA OPS Series - Factory Command; System Command

6-7. Factory Command
Reset, restore, back up calibration data of power supply.
FACTory:CYCling {CLEar}
Previous data cannot be restored when an reset is operated in Cycling mode.
Read reference
"
5
-
3 CYCLING CLEAR
"
for more information about reset data description
Read
reference
"5
-
3
.
CYCLING
CLEAR"
for
more
information
about
reset
data
description
> CLE Reset Cycling mode memory.
ex) fact:cyc cle
FACTory:USER-Memory {CLEar}
Reset user's memory, and when it is operated, previous data cannot be restored.
Read reference "5-4. USER-MEM CLEAR" for more information about reset data
> CLE
>
CLE
ex) Reset User memory.
FACTory:CALibration {REStore|BACkup}
Command that backup & restore Calibration.
Read reference "5-5. CALI-RESTORE" and "5-6. CALI-BACKUP" for more information.
> RES
adopt backup description to current system
>
RES
adopt
backup
description
to
current
system
.
> BAC Backup current saved description to fixed memory.
ex1) fact:cal res
ex2) fact:cal bac
6 8 System Command
6
-
8
.
Sy
s
t
em
C
omman
d
Various commands about power supply panel.
SYSTem:BEEPer
Command making alarm when a error occurs.
ex) syst:beep
Alarm starts
SYST BEEP {OFF|ON|0|1}
SYSTem:BEEPer
{
OFF
|
ON
|
0
|
1
}
When there is any events, there will be a alarm. This command is about panelling alarm sound.
When it is disabled, alarm sound will not be occurred.
> ON OR 1 Allow alarm sound.
> OFF OR 0 Forbid alarm sound.
ex1) syst:beep off
Forbidden
2) t:b
All d
ex2
)
syst:bee
p
on
Allowe
d
SYSTem:BEEPer?
Command that checks alarm condition of power supply.
Return value " 0 "
Disable.
" 1 "
Enabled.
- 71 -