ODA OPS Series - Remote Calibration Error

7-3. Remote Calibration Error
Read reference "4-6. Calibration(for GPIB) using REMOTE INTERFACE"
-20, "Ignored min run under volt"
This error occurs when Max or value is activated while Min voltage value is not operated.
Sequence : Min → VALUE → MAX → VALUE
Sequence
:
Min
→
VALUE
→
MAX
→
VALUE
-21, "Ignored min save under volt"
Operated MAX Value without voltage min value.
Sequence : Min → VALUE → MAX → VALUE
-22, "Invalid min value use under volt"
This error occurs when you have send value without activating max value after operating
This
error
occurs
when
you
have
send
value
without
activating
max
value
after
operating
minumum value.
Sequence : Min → VALUE → MAX → VALUE
-23, "En route to cal the curr"
This error occurs when you have send voltage calibration while current calibration.
-
24
"
Over volt min parameter
"
-24
,
Over
volt
min
parameter
This error occurs when Minimum value is out of range.
Read reference "4-5. CALIBRATE Setting Range"
-25, "Under volt max parameter"
This error occurs when voltage max value range is out of lowest limit.
Read reference "4-5. CALIBRATE Setting Range"
-26, "Over volt max parameter"
This error occurs when voltage max value range is out of highest limit.
Read reference "4-5. CALIBRATE Setting Range"
-27, "Ignored min run under curr"
This error occurs when max value is operated when current min value is not operated.
Se
q
uence : Min → VALUE → MAX → VALUE
Sequence
Min
VALUE
MAX
VALUE
-28, "Ignored min save under curr"
Operated MAX value before operating current min value.
Sequence : Min → VALUE → MAX → VALUE
-29, "Invalid min value use under curr"
This error occurs when you have sent value again without o
p
erating maximum after minimu
m
This error occurs when you have sent value again without operating maximum after minimum
Sequence : Min → VALUE → MAX → VALUE
- 76 -