1. General Information
1-1. Feature
ODA Technologies's OPS-Series are high efficiency, high performance programmable DC power supply
RS232C & GPIB(IEEE-488.2) interface based on SCPI (Standard Commands for Programmable
instrument) protocol In addition It is designed to be equipped in 3U
*
-
.
,
.
General Functional Features
▌Simple setting using jog & shutttle.
▌Output voltage, current block & restore function (Output ON/OFF)
▌Front panel's key lock function
▌Caution alarms on events
▌Hi h & Hi h li it f l ti
High accuracy & High limit of resolution
▌Built-in Remote Sensing for Load Voltage(V-Sensing)
▌Over Voltage Protection(O.V.P) / Over Current Protection(O.C.P) Secure Function
▌Excellent Load Regulation & Line Regulation
▌Operating condition(Voltage,Current,OVP,OCP) Store & Recall up to 10 slots.
▌Store Error message (up to 10 messages)
▌3U * 19inch Half-Rack compatible
Remote Interface Features
▌GPIB(IEEE-488.2) & RS232C Interface
▌SCPI(Standard Commands for Programmable Instruments) compatible
▌High speed setting & measument
▌plenty of Commands equipped
▌Simple interface setting using front panel I/O config
▌Insulation with instrument & Floating Logic realization
▌SCPI programming grammatical order check options equipped
Calibration Features
▌adopted Software Calibration do not requires inside correction
▌Simple calibration operating using Independence or PC Interface
Factory Function Features
▌Initialization memory function up to 10 memories
▌Initialization mamory function up to 100 cycling mode memories
▌Calibration restoration function
▌Calibration back up function
Cycling mode Features
▌Operating realization by instrument itself
▌Safe storation used by permanent memories
▌Store Voltage Current Slope time Delay time each step up to 100 slots
,
,
,
▌Cycling mode tests available using sequence panel
Self Test Features
▌Front panel Test ▌ADC H/W Error Test
▌Remote interface Test ▌UnRegulated condition Test
Memory data verification Te
▌ADC/DAC Calibration verification Test
- 6 -