ODES UTV Desertcross 1000cc-3 - FRONT OIL SEAL (ENGINE DRIVE SHAFT)

3. ENGINE
3-
80
REQUIED
Tightening torque
10N·m 士 1 N·m
(89lbf·in 士 9lbf·in)
Front Bearing Cover Installation
FRONT OF ENGINE
1. Water pump cover
2. Oil seal front side
3. Oil cover
4. Drive shaft
FRONT BEARING COVER SCREWS
Service product
LOCTITE243
(BLUE)
(P/N293 800 060)
Tightening torque
10N·m 士 1 N·m
(89lbf·in 士 9lbf·in)
Engine Drive Shaft Installation
Finally check for axial play of the drive shaft
FRONT OIL SEAL
(ENGINE DRIVE SHAFT)
Front Oil Seal Replacement
(Engine Drive Shaft)
NOTE: The front oil sea1 can be replaced with the
engine installed.
1. Remove front propeller shaft.
2. Remove adapter sleeve between propeller shaft
and front engine drive shaft.
3. Remove the front bearing cover, refer to
ENGINE DRIVE SHAFT REMOVAL /
INSTALLATION in this subsection.
4. Remove drive shaft seal from bearing cover.
1. Bearing cover
2. Oil seal
5. Install drive shaft oil seal using the following
1. Bearing cover
2. Oil seal
3. Oil seal installer
REQUIED
ERIVE SHAFT OIL
SEAL
6. Reinstall remaining parts in the reverse order of
removal.
REAR OIL SEAL
(ENGINE DRIVE SHAFT)
Rear Oil Seal Replacement
(Engine Drive Shaft)
1. Remove rear bearing cover , refer to ENGINE
DRIVE SHAFT REMOVAL / INSTALLATION in
this subsection.
2. Remove drive shaft seal from bearing cover.
3. Remove 0-ring from bearing cover.