3. ENGINE
3-
1. Counter shaft
2. Distance sleeve
3. O-ring
Gearbox Bearings
If necessary heat housing up to100°C(212°F)
before removing ball bearings.
Clean oil, outside and inside, from
housing before heating.
NOTICE Always support gearbox housings
properly when ball bearings are removed.
Housing damages may occur if this procedure
is not performed correctly.
To remove ball bearings of countershaft (right
cover) and main shaft (left cover) use following
tool .
For ball bearings of countershaft (1eft cover)
and main shaft (center housing) push with a
suitable puller from outside in .
1. Ball bearing countershaft
2. Right cover
1. Screw
2. Ball bearing countershaft
3. Ball bearing main shaft
4. Left cover
1. Ball bearing main shaft
2. Center housing
To Next Page
Loading...
