EN
16
4.3 Connecting to TV-Signal Input
Connect the TV signal cable (the antenna cable, for example) to the Antenna Input Jack on the back of the
unit so that you can receive television programmes.
After connection, turn on the power of the unit. Then press the SOURCE button to select TV or DTV mode
and conduct program selection.
Note
Whether and how many DVB-T channels can be received by this device, is strongly depending
on the operational place, and the DVB-T signal strength in this Area.
DVB-T radio in particular is very limited and not available in most locations
Please note that for using of DVB-T after each larger local changes, a new channel search
should be accomplished. Since the frequency of the Channels may Vary from region to region.
ODYS PRIME
To Next Page
Loading...