www.oes-scoreboards.com | 1.877.652.5833
4056 Blakie Rd., London ON Canada N6L 1P7
Issued: 2021-10-21
SETTING DEFAULT VALUES ON ISC900 CONTROLLER
It is recommended to load controller default settings for ISC9000 when the firmware is upgraded.
System defaults should also be loaded if the controller does not seem to be operating correctly.
The following steps are required to load system default setting in the ISC9000 controllers:
1) Turn power off to the controller.
2) Turn power on to the controller.
3) The OES logo and information screen will appear.
4) When the program information screen appears press the number “1” key three times while on
that screen as indicated below by red arrow:
5) If the controller system default settings are performed correctly the following screen will appear
on the controller.
6) When controller advances to the next screen the controller system default settings have been
loaded successfully.
To Next Page
Loading...
Need help?
General
