OHAUS AP110 - Turning the Balance On; Understanding Display Indications

19
Turning the Balance ONTurning the Balance ON
Turning the Balance ONTurning the Balance ON
Turning the Balance ON
1. After the Self Test in the Installation Section is completed (power applied to the
balance), make sure the pan on the balance is clear, then, close the chamber
doors.
2.
Display IndicationsDisplay Indications
Display IndicationsDisplay Indications
Display Indications
The following table describes each of the display indicators.
DISPLAY INDICATORSDISPLAY INDICATORS
DISPLAY INDICATORSDISPLAY INDICATORS
DISPLAY INDICATORS
OPERATION