OHAUS AV53 - 2 Installation; Unpacking; Installing Components; Assembly of Models AV412, AV812, AV2101, AV2102, AV3102, AV4101, AV4102, AV8101

Adventurer ProEN-4
2 INSTALLATION
2.1 Unpacking
Carefully remove your Adventurer Pro balance and each of its components from the package. Save
the packaging to ensure safe storage and transport.
2.2 Installing Components
Use the illustrations and instructions below to identify and assemble your Adventurer Pro model
with its components. All components must be installed before using the balance.
2.2.1 Assembly of Models AV412, AV812, AV2101, AV2102, AV3102,
AV4101, AV4102, AV8101
1. Insert the Sub-platform on the Mounting Cone located in the center of
the balance. Align the Sub-platform so that it is fully seated on the cone.
2. Place the Weighing Pan on the Sub-platform.
3. For applicable Adventurer Pro models, place the Wind Ring over the pins located on
the perimeter of the balance.
Sub-platform
Mounting Cone
Weighing Pan
Pin
Wind Ring
(INCAL models)
Note: Assembly instructions also apply to models with the suffix C, CR, CU, R or U.
3 page 3 to 8.pmd 3/3/2005, 9:33 AM4