Ohmeda Biox 3700 - Page 108

COMPUTER INTERFACE
CONTROL MODE
Computer Communication with Ohmeda Biox 3700 Oximeter
CONTROL MODE
EXAMPLE
1118-301
In order to change the Pulse Volume, press in
succession ESCAPE CHI ENTER
The H is the capital letter which represents the Pulse
Volume and the 1 (one) is the parameter to which you
want to set the Pulse Volume.
If the information has been entered correctly, the Pulse Volume should
change. If the information has been entered incorrectly, a WHAT?
appears on the computer screen and a beep is heard.
If the Pulse Volume has not gone to one:
* press the CAPS LOCK key
* press ESCAPE CHI ENTER
Entering and Enabling
The following information is important to know when using the
Control Mode:
Parameters
To set an alarm limit or pulse volume to off, input 0
(zero) as the parameter.
If no parameter needs to be input, press ENTER after
the capital letter entered.
The % and BPM do NOT need to be entered with the
parameter for Sa02 and Pulse Rate limits.
The Sa02 alarm limits change in steps of one. The
Pulse Rate alarm limits change in steps of five.
The message WHAT? appears on the computer screen along
with an audible beep if:
* the Oximeter does not recognize a letter or
parameter field
* or a parameter has been omitted.
WHAT?
05/09/86
82b