Ohmeda Biox 3700 - Page 95

COMPUTER INTERFACE PROGRAMMING
Programming the IBM PC to Communicate with the Ohmeda Biox 3700 Oximeter
10. If the previous steps have been performed correctly, the Ohmeda
Biox 3700 Oximeter should be communicating with the IBM PC in the
Auto-Output Mode.
One line of data is output to the computer screen every two
seconds. The message should look like the following:
:SA02-XXX PR-XXX
11. Proceed to manual section: Computer Interface "Communication",
which discusses how to use the different modes.
NOTE: Once the program has been saved, it does not need to be retyped every
time the Computer Interface is used. The program just needs to be run. To
do this from the DOS Prompt:
* type BASICA and press ENTER after the prompt
* type RUN"3700COM.BAS" and press ENTER.
1118-301 05/09/86
s^%.
79a