Oki 182 - Page 115

_________ APPENDIX B SOFTWARE NOTES
We'll step you through our sample patch, taking each
menu in turn.
We suggest that you try this patch so you
can
see how it works, then make any modifications for
your
own requirements.
MENU ITEM
Q: CHARACTER PITCH This item is intended
for changing character
width. We're going to use it to set
the printer to print in the emphasized print mode. Begin by
entering
Q. The screen will display this:
Set alternate character pitch
If your pril"lter allows, you can char-Ige the character"" pitch
within a document. This sequence specifies the characters
required tel set alterrlate character pitch. Check. YCII .. tr priYJter
rnar-illal for code sequeYlce. What sequence clf characters should
be ser.t tCi the printer at "'~"PA" in your text?
Set alternate character pitch function code sequence is
currently: lBh 3Ah
Enter "e" to chaY'tge~
or press <RETURN} to leave unchanged.
Type ~. The following display will appear:
You can enter a value in ASCII, decimal, or hexadecimal
codes. Precede each entry with these prefixes:
ASCI I (:AA enters ASCII AA, a single value)
Hexadecunal
(,41 enters hexadecimal 411
Decimal (#61 enters decimal 61)
Te. erlter a sequence Qf chara.cters, er.ter each Cine separately,
fe-lie-wed by <RETURN>.
Press (RETURN) to leave a value unchanged.
EYlter a pet"iod (.) arid press (RETURN) tel terrniYlate a sequence
and to eliminate all subsequent values.
These special characters
'r"'equ 1 re he~adecimal input:
(RETURN> eMI
,OD
Pet"icld (.)
,2E
AH (backspace: AHI
,08
Maximum entries for set alternate character pitch function is 4.
Currerlt
New
Value
Value
OOh
99