Oki 182 - Page 54

ML182/183 ________________ _
-
-
The second time, the first line is printed standard width. Because the
SO
command is not in effect by the end of a line. To return to stan- -
dard size
printing (10 characters per inch) you have to put in
CHR$(30),
like this: -
-
-
20 LPRINT CHR$(14);"HELLO";CHR$(20) " U U U HELLOW AGAIN"
-
-
NOTE: U means space.
That is what you should get:
-
-
flfEL
LO
-
M.ELLO
HELLO· H~H.~ N
-
-
To avoid any unpleasant surprises, you may want to insert codes at
-
the end
of a document to cancel whichever feature(s) you selected
and
to reset the printer to the normal startup condition.
-
ESCape Sequences
-
Many of your IBM-compatible MICROLIN E 182/183 printer's special
printing features are controlled by a combinaton of ASCII codes
beginning with the non-printable code, ESC. Commonly called an
ESCape sequence, this alerts the computer to interpret the next
code number as part of an instruction, not as a printable character.
-
For
example, if you want to put tab stops at every fifth column, you
would use the ESCape sequence ESC D (5) NULL. (5) is binary.
-
Looking at the ASCII chart on page 129, this is how you would
change the horizontal tab command into BASIC:
-
-
42