Operating instructions > 37
ITEM FUNCTION SETTING
TOF (Continuous) Select the reference position
for the TOF position when
auto loading continuous
form paper from the rear of
the printer. (Up to the mid-
section of characters in the
first line.)
"1Chr. Set Pos." is printed
if the TOF position is set
by using SHIFT + PARK
switches.
2.12 mm (1/12 in)
4.23 mm (1/6 in)
6.35 mm (1/4 in)
8.47 mm (1/3 in)
10.58 mm (5/12 in)
12.7 mm (1/2 in)
14.82 mm (7/12 in)
16.93 mm (2/3 in)
19.05 mm (3/4 in)
21.17 mm (5/6 in)
23.28 mm (11/12 in)
25.4 mm (1 in)
27.52 mm (13/12 in)
1Chr. Set Pos.
Initial Position This is the position of the
paper when the paper is
already loaded at power on.
(For continuous form mode
only.)
Print
Tear OFF
Auto Eject Position Select a printable area at
the bottom of cut sheets of
paper in cut-paper mode
(the character centre
position).
6.35 mm (1/4 in)
14.8 mm
Page Length (Cut
Sheet)
Select the page length of
cut-paper.
3.5 in, 4 in, 5.5 in, 6 in, 7
in, 8 in, 8.5 in, 11 in, 11
2/3 in, 12 in, 14 in, 17 in,
5 in, 3 in, 3.25 in
TOF (Cut Sheet) Select the reference
position for the TOF position
when feeding cut-paper in
manual mode. (Up to the
mid-section of characters in
the first line.)
"1Chr. Set Pos." is printed
if the TOF position is set
by using SHIFT + PARK
switches.
2.12 mm (1/12 in)
4.23 mm (1/6 in)
6.35 mm (1/4 in)
8.47 mm (1/3 in)
10.58 mm (5/12 in)
12.7 mm (1/2 in)
14.82 mm (7/12 in)
16.93 mm (2/3 in)
19.05 mm (3/4 in)
21.17 mm (5/6 in)
23.28 mm (11/12 in)
25.4 mm (1 in)
27.52 mm (13/12 in)
1Chr. Set Pos.
To Next Page
Loading...
