Oki 6300FB - Page 38

Operating instructions > 38
ITEM FUNCTION SETTING
Wait Time Select the waiting time
between setting paper on
the tray and feeding it while
the printer is waiting for
paper to be fed in cut-paper
manual feed mode.
500 ms
1 sec
2 sec
FF Function
*EPSON only
Select the feed operation
upon receiving the FF code
after feeding cut-sheets.
Eject
Form Feed
I-Prime Select whether to print or
clear buffer contents upon
initialisation by receiving
I-PRIME.
Invalid
Buffer Clear
Buffer Print
Auto Feed XT
*EPSON only
Set the validity of an Auto
Feed XT signal.
Valid
Invalid
I/F Bi-Direction Set whether to return
a device ID or not in
accordance with IEEE1284.
Enable
Disable
TOF Adjustment
(Cut Sheet)
Select an adjustment value
for the reference position in
regard to the TOF position
of cut-paper/passbooks.
The position moves to the
rear of the form by [+] and
to the top of the form by [-]
in 1/60 in increments.
-7 ~ -1
0
+7 – +1
Rear Load
Adjustment
Select an adjustment value
for the reference position in
regard to the TOF position
of a continuous form.
The position moves to the
rear of the form by [+] and
to the top of the form by [-]
in 1/60 in increments.
-7 ~ -1
0
+7 ~ +1