Oki 6300FB - Page 51

Troubleshooting > 51
PROBLEM CAUSE ACTION
When cut sheets are
used, the content of a
single sheet is printed
on two sheets.
The paper setting
selected in the application
does not match the
physical paper size.
Match the paper setting
selected in the application
with the physical paper in
use.
It does not match the
lines per page as the
printer automatically
detected.
Leave enough top and
bottom margin in the
application.
Correct the cut sheet LF
adjustment.
The content of a single
line is printed in two
lines.
The left and/or right
margins are not correctly
selected.
Reselect the left and right
margins correctly in the
application.
When continuous forms
are used, several blank
lines appear in the
printout.
Tear-off perforation
spacing is selected.
Cancel tear-off
perforation spacing.
Broken and uneven
vertical lines.
This may happen in
bidirectional printing.
Use Print Registration in
the adjustment mode to
adjust.
Too large or small line
spacing.
Line spacing is not
selected correctly.
Reselect line spacing
correctly in the application.
Split print
Blanks appear in
graphic printout.
This is a paper feed
error, which is especially
notable in printing regular
characters.
This is not a failure.
Blanks or deformed
characters appear in
double height type or
other extended types.
This is a paper feed
error due to line feeding
in printing a single
character.
This is not a failure.
Use the printer's built-
in fonts when you print
important documents or
bills.
Improper cut sheet feed
No paper feed. Sheets are located off the
paper guide.
Load sheets with their left
edges against the paper
guide.
Sheets are not loaded to
the end.
Load sheets to the end.