Printing > 22
7. From the Source drop down select the loaded paper tray.
8. Click the Paper Size drop down and select the size of the original document.
9. Click OK.
10. Click Print in the Print dialog box to start printing.
P
RINTING
ON
C
USTOM
S
IZE
P
APER
/L
ONG
P
APER
This section explains how to print on custom size paper such as long paper.
The paper sizes that can be set on this printer are as follows:
a. Paper that extends beyond 356 mm (14 in.), the print quality on that part of the paper cannot be
guaranteed.
L
OADING
C
USTOM
S
IZE
P
APER
The way to load custom size paper with the long edge shorter than 356 mm in trays 1 to 4
is the same as loading standard size paper. For details, refer to “Loading Paper” on
page 27.
To load long paper in Tray1, follow the procedure below:
1. Pull the paper tray out to its maximum.
NOTE
> The custom paper size has to be set on the control panel and the printer
driver, refer to “Setting Custom Paper Sizes” on page 23.
> You must set Auto-sense to Off before setting the paper type.
> To load long-size paper with the long edge exceeding 356mm, load the
paper with the edge protruding from the tray.
TRAY LONG EDGE SHORT EDGE
Tray 1
215.9 - 1219.2mm (8.5 - 48in)
a
76.2 - 127mm (3 - 5in)
Tray 2, 3 and 4
215.9 - 355.6mm (8.5 - 14in)
a
98.4 - 148mm (3.875 - 5.83in)
NOTE
Pull the extendable part out to its maximum. For details on the procedure to
extend the paper tray, refer to “Loading Paper” on page 27.
To Next Page
Loading...
Need help?
General
