Loading Paper > 28
4. Hold the grip of the paper tray and pull its extendable part to the front until it
reaches its maximum.
5. Squeeze the length guide and slide it to the desired paper size (1). Squeeze the
right width guide and slide it to the desired paper size (2).
6. Load the paper with the side to be printed facing up and with all four corners
aligned.
7. Close the lid of the paper tray and push the tray completely into the printer.
8. Depending on the types and sizes of the loaded paper, you need to configure
settings on the control panel. Change the paper type when non-plain paper such as
recycled paper, heavyweight paper or transparencies are loaded. Configure the
paper size when custom size paper is loaded.
CAUTION!
> Do not place paper over the right width guide.
> Do not load paper exceeding the maximum fill line or the
maximum capacity allowed.
> Align the right width guide with the paper width correctly. If the
right width guide is not in place, the paper will not be properly
fed and this may cause paper jams.
> The lid of the tray must be firmly closed. If not, the paper might
become misaligned.
NOTE
You can use Tray1 to manually feed paper. Change the settings in the Printer
Driver to Manual Feed. Feed one sheet a time, and press Enter each time a
sheet is fed to start printing.
To Next Page
Loading...
Need help?
General
