Daily Care > 45
Cleaning Procedure
The following procedure explains how to clean the feed roller set in the paper tray. Follow
this procedure also when cleaning the feed rollers inside of the printer and the tray module.
1. Pull the paper tray out of the printer.
2. While pushing the retard part (see right diagram) down (1), widen the tab on the
feed roll to loosen it (2) and then slowly remove the feed roller from the shaft of the
paper tray (3).
3. Wipe the rubber parts with a wet but well-wrung soft cloth.
NOTE
The feed roller is a regular replacement part.
To Next Page
Loading...
Need help?
General
