C3200n User’s Guide
Troubleshooting • 111
Shading on unprinted sections
Toner rubs off when you rub the printed
surface.
Change image drum.
Possible cause Remedy
Paper has been
affected by static
electricity.
Store paper within specified temperature and
humidity levels. See “Specifications” on
page 120.
Paper is too thick. Use recommended paper. See “Paper Weights”
on page 10.
Toner is low. Replace toner cartridge . See “Toner Cartridge”
on page 28.
Possible cause Remedy
Media Weight and
Media Type settings
may not be
appropriate.
Set the value of media weight in the menu to
the next heaviest one (MEDIA MENU → YYY
MEDIA WEIGHT).
Packing materials were
left on the fuser when
it was installed.
Careful! Fuser my be HOT!
Open the top cover and check to be sure that
all the packing materials were removed from
the fuser. To remove the fuser see “Fuser” on
page 51.
Remedy
To Next Page
Loading...
Need help?
General
