C3200n User’s Guide
Menus • 76
System Adjust Menu
Notes:
• Factory default settings are shown in bold.
• Items with a dagger (†) only appear when the Duplex
Unit is installed.
Item Settings Explanation
X ADJUST -2.00MILLIMETER TO
+2.00MILLIMETER
Default = 0.00
Adjusts overall print position
horizontally in 0.25
increments.
Y ADJUST -2.00MILLIMETER TO
+2.00MILLIMETER
Default = 0.00
Adjusts overall print position
vertically in 0.25 increments.
DUPLEX X ADJUST† -2.00MILLIMETER TO
+2.00MILLIMETER
Default = 0.00
Adjusts overall print position
of print face horizontally in
0.25 increments.
DUPLEX Y ADJUST† -2.00MILLIMETER TO
+2.00MILLIMETER
Default = 0.00
Adjusts overall print position
of print face vertically in 0.25
increments.
DRUM CLEANING OFF
ON
If you are experiencing
horizontal white lines on your
printed pages, enter the
menu and temporarily
change this setting to ON,
then send a one page print
job. This will cause an extra
blank sheet to print, cleaning
the drum prior to printing.
Careful! Leaving this set to
ON will reduce the image
drum life.
To Next Page
Loading...
Need help?
General
