C3200n User’s Guide
Menus • 70
System Configuration Menu
Note: Factory default settings are shown in bold.
Items Settings Explanation
POW SAVE
TIME
5
15
30
60
240
Adjusts the time before the printer
automatically switches into power saving
mode. In this mode power consumption
is reduced, but when a job is sent the
printer will require a warm-up time of up
to 1 minute before printing can begin.
CLEARABLE
WARNING
ON
JOB
When ON, non-critical warnings, such as
requests for a different paper size, can
be cleared by pressing the
ON LINE
button. When set to JOB, they are only
cleared when the print job resumes.
MANUAL
TIMEOUT
OFF
30
60
Specifies how many seconds the printer
will wait for paper to be fed before
cancelling the job.
WAIT TIMEOUT 5 to 300 SEC
Default =
90
seconds
Specifies how many seconds the printer
will wait when received data pauses
before forcing a page eject.
LOW TONER CONTINUE
STOP
Specifies whether the printer should
continue printing after a low toner
condition is detected. If you change this
to STOP, when low toner is detected, the
printer goes off line.
JAM RECOVERY ON
OFF
Specifies whether the printer should
perform jam recovery after a paper jam
has occurred. If ON, the printer will
attempt to print again any pages lost due
to a paper jam once the jam has been
cleared.
ERROR REPORT ON
OFF
Change this to ON if you wish the printer
to print the error details when an error
occurs.
To Next Page
Loading...
Need help?
General
